Fostex D-160 Owner's Manual page 19

25. Redo key [REDO]
Pressing this key after you press the UNDO key restores the status obtained before you
undo recording or editing. This key is activated only when the recorder transport section
is stopped.
* Refer to pages "75" and "85" for more information about the Redo operation.
26. Undo key [UNDO]
After using an edit function such as Paste, or Erase, or after auto punch in/out recording,
pressing this key will restore the previous status before editing or recording.
This key is activated only when the recorder transport section is stopped.
* Refer to pages "75" and "85" for more information about the Undo operation.
27. Erase key [ERASE]
This key is used to erase a specified area or all data after a specified point on certain
"READY" track(s), or all the data in a specified Program.
Use the Auto Punch In/Out points and the RECORD TRACK select key to specify the area to
erase.
To erase all data in a Program, press the STORE key while holding down the HOLD/> key
to select the Program, then press the ERASE key.
All data recorded in the Program will be erased. You do not need to set a track in READY
mode.
* Refer to page "96" for more information about the Erase operation.
28. Vari-pitch key [VARI PITCH]
Use this key to turn the Vari-pitch function on and off. When this function is enabled, the
corresponding LED lights up. When this function is disabled, the LED turns off.
The range of pitch variation for playback and recording is +/-6.0%, in 0.1% steps.
Press the RECALL key, and then the VARI PITCH key to display the current pitch data.
To change the pitch data, use the JOG dial to change the value while the pitch data is
displayed.
You can also change the playback speed when the data is being played back with the Vari-
pitch function ON.
* To quit the pitch data display, press the EXECUTE/YES key, the EXIT/NO key, or the
STOP button.
<Note>
Even when the vari-pitch data is set to 0.0%, pressing this key will turn the LED on.
<Note>
You cannot change the pitch data while recording. If the Vari-pitch function was on, the unit will
use the pitch data previously set.
<Note>
The Vari-pitch function will be automatically turned off in the following situations:
* When you turn on the power to the unit (The pitch data will be reset to 0.0%.)
* When you set Slave mode ON. (The pitch data remembers the previous setting.)
* When you set up the digital input tracks and "DIGITAL" appears on the display. (The pitch data
remembers the previous setting.)
If you have installed an optional Model 8345 TC/SYNC card in the D-160 and you have set the
"Word Out?" menu in the Setup mode to "8345," the Vari-pitch function turns on even during digital
input via DIGITAL IN.
* Refer to page "56" for more information on the Vari-pitch function.
* Refer to page "123" for more information on Slave mode.
* Refer to page "60" for more information on digital signals.
D-160 Owner's Manual (Names and Functions)
19