Fostex D-160 Owner's Manual page 94

D-160 Owner's Manual (Edit function)
Entering and storing the paste Punch In point
1. Press the RECALL key, and then the AUTO PUNCH IN key (or press only the
AUTO PUNCH IN key). The D-160 will enter the edit mode.
2. Move the cursor to the digit you wish to edit using the HOLD/> key or the
SHUTTLE dial, and set the value using the JOG dial.
3. After setting the time value, press the STORE key, and then the AUTO PUNCH
IN key.
The time value will be stored as the start point of the pasting area, and the
display will return to the previous screen.
Executing the paste operation
4. Press the PASTE key.
When the PASTE key is pressed, "Move Paste" is momentarily shown in the display,
then "Paste Repeat = 01 (01 blinks)" and "SURE?" will blink, and the move source track
display will be lit.
5. Specify the Move & Paste destination track and the number of repeats to paste.
* Specifying the Move & Paste destination track:
Select the destination track using the RECORD TRACK select key.
You do not need to specify a track if you are going to Move & Paste data in the
copy source track.
* Specifying the number of repeats to Move & Paste:
Turn the JOG dial to change the blinking number "01" to any value between 1
and 99. If there is not enough free space on the hard disk, the repeat time will
be limited to a number less than 99, and you will be unable to specify a larger
number when you turn the JOG dial.
6. Press the EXECUTE/YES key.
Simultaneous with the execution of paste, the paste section length converted to
mono track time length will be shown in the upper line of the display and
"Move Paste," "COMPLETED!" displayed after completing the paste.
Press the EXIT/NO key to return to the previous screen.
Now the audio data on the Clipboard has been pasted to the specified
track starting with the AUTO PUNCH IN point.
For example, executing the function with a repeat number of "Paste Repeat=
03" (three times) will paste the data as shown in the diagram below.
Repeat number of "01"
Repeat number of "03"
* To cancel the paste operation, press the EXIT/NO key while the message "SURE?" is
AUTO PUNCH IN point
blinking on the display.
If you wish to cancel the paste operation after you press the EXECUTE/YES key,
press the STOP button or the EXIT/NO key before the "COMPLETED!" message
appears on the display.
If you abort the paste operation using this procedure (even in the middle of the
operation), no data will be pasted.
1
1 2
94
3