Fostex D-108 Supplement Owner's Manual

D-108 Owner's Manual Supplement (V1.10)
The functions explained here are additions to the main manual because of our version-up
(V1.10) of the D-108 software. Please read this manual together with the main manual
before operating the D-108.
1. Large capacity hard disks can now be used.
It is now possible to use E-IDE hard disks with a recording capacity up to approximately
30GB (FS=44.1kHz) as the D-108's recording media (current drive/backup drive).
Please refer to "List of hard disks checked for operation" to make sure any product you
are about to use will operate correctly.
<NOTE>: When formatting a large capacity hard disk, the time required to format will be in
relation to disk size. As a general estimate, it requires about 15 minutes to format 1GB and
thus, as an example, it will take about 7 hours for a 30GB hard disk.
Maker
Quantum
2. In the BAR/BEAT/CLK (bar/beat/clock) time base, the offset figure of the BAR
that indicates the head of the disk can now be edited.
Although [Time Base] is explained in [Before Operating] the main D-108 owners manual,
the unit to indicate the present traveling position, MTC (MIDI time code) or BAR/BEAT/
CLK (bar/beat/clock) is now also employed in addition to ABS (absolute time).
Because of this, the figure indicating the present disk position will be different depending
on the selected time base. When the D-108 is in the initial setup state and the MTC offset
display at [MTC 00h 59m 57s 00f] for the disk in the head position (ABS 00m 00s 00f) or,
at BAR/BEAT/CLK, it will display [-002bar 1 beat 00clk].
Before version-up V1.10, this offset figure could be changed only for MTC, and the BAR/
BEAT/CLK offset figure was fixed to [-002bar 1beat 00clk].
But, with V1.10, the BAR offset figure in BAR/BEAT/CLK can now be changed to any
figure within the -002 ~ -009 range.
In the initial setup state of the D-108, [-002bar 1beat 00clk] will always be displayed and
the bar offset figure will be [-002bar].
To setup the offset figure of this BAR/BEAT/CLK display, execute it in the SETUP mode of
the D-108, the same as the setup of the MTC offset figure. Please read the reverse side
operating procedures. For setup of the MTC offset, refer to the explanations in the SETUP
mode of the main owners manual.
<List of hard disks checked for operation>
Model
Fireball CX
Fireball CR
Disk Capacity
6.4GB, 10.2GB, 13.0GB, 20.4GB
4.3GB, 6.4GB, 8.4GB, 13.0GB