Midi Sync Signal Out Setting (Midi Sync Out?") - Fostex D-160 Owner's Manual

D-160 Owner's manual (SETUP mode)
2-8. MIDI Sync Signal Output Setting ("Midi Sync Out ?")
This mode sets up the type of MIDI sync signal for external MIDI equipment.
The type of signal the D-160 outputs is either MIDI Clock & Song Position Pointer or MTC
(MIDI Time Code). Choose one so that the external MIDI equipment can recognize it
when synchronizing to the D-160.
In case of the MIDI Clock & Song Position Pointer, you need to set the section "2-2. Time
Signature" and section "2-3.Tempo as previously mentioned."
In case of the MTC ( MIDI Time Code), you need to set the section "2-9. MTC Frame Rate",
"2-10. MTC Offset Time" and "2-11. MTC Offset Mode" described below.
* See page "117" "MIDI Synchronization Function" for details of the MIDI sync.
<Note>
The D-160 will still run the time counter in PLAY mode even after the ABS END. Thus, it will
continue generating the MIDI Clock & Song Position Pointer and MTC even if you have not
recorded anything, provided a tempo map has been set up.
* Initial setting : CLK
* Available setting : CLK, MTC, Off
* This setting is applicable song by song.
* This setting can be saved or loaded as a part of the song data.
* The setting is memorized even when the power is off.
*
1. Press the DISP SEL key and choose the flashing SETUP mode on the display. Then, press the
EXECUTE/YES key.
The SETUP display will stop flashing.
2. With the JOG dial, choose "MidiSyncOut?".
The "?" display will start flashing. The display will also show the current setting.
In the case of initial setting, it will show CLK.
3. Press the EXECUTE/YES key.
The current setting will start flashing "**" which indicates it is ready to change setting.
4. With the JOG dial, enter a required Midi Sync Signal.
Choose the type of MIDI signal you want.
If you choose "CLK", the D-160 generates the MIDI Clock & Song Position Pointer.
If you choose "MTC", the D-160 generates the MIDI Time Code.
If you choose "Off", the D-160 generates no MIDI Sync signal.
5. Press the EXECUTE/YES key after you have entered the Midi Sync Signal you wanted.
The setting will be registered and the display will go back to step 2 above.
* Press either the "STOP" button or EXIT/NO key to return from the second step menu to
the first or to quit SETUP mode. The menu will go backwards each time you press either key
so that you can correct the setting, choose some other SETUP mode or eventually return to
the normal time base display.
Clock : MIDI Clock & Song Position Pointer, MTC : MIDI Time Code
Make sure to choose the right program before setting up this mode.
OL
0
3
6
9
12
18
24
30
42
_
1 2 3 4 5 6 7 8 9 10 11 12 13 14
150
SETUP
44.1kHz
15 16