Compatibility With D-90, D-80 (V2.0),Dmt-8 (V2.0), And Dmt-8Vl; And Dmt-8Vl - Fostex D-160 Owner's Manual

D-160 Owner's Manual (Saving and loading data)
4. Compatibility with D-90, D-80 V2.0, DMT-8 V2.0, and DMT-8
"FDMS-3 (Fostex Disk Management System-3)" for recording format of the D-160, and
"FDIO-1 Ver2.0 (Fostex Data In/Out-1 Ver2.0)" for save/load format of song data, are
employed. In the D-90, "FDMS-2 Ver2.0" and "FDIO-1 Ver2.0," in the D-80/D-80 Ver2.0
and DMT-8VL, "FDMS-2" and "FDIO-1", furthermore, in the DMT-8, "FDMS-1" and "FDIO-
1," respectively, are employed.
Due to these conditions, the hard disk recorded in the D-160 cannot be installed and
used in another equipment. However, as the save/load format is same for the D-160 and
D-90, data saved from the D-160 to an external digital equipment (adat or DAT) can be
loaded in 8 track units to the D-90 or data saved in the D-90 can be loaded in D-160.
Refer to list below for functional comparison of each product.
During save/load using DAT and Adat, independent save/load in 8 track units is possible.
In this case, the data in 8 track units are not distinguished as tracks 1~8 or 9~16 but simply
handled as eight track data.
Therefore, because this 8 track data is compatible with the D-90 if it is in 8 track units (any
one combination of 1~8, 9~16 or 17~24), data saved from the D-160 can be loaded in tracks
1~8 of the D-90.
In this case, data in the tracks which were not loaded will remain intact.
Program
Editing the memory data
Setting of the time base
Backup of the time memory
SETUP mode
Sampling frequency
Setting of the time signature
Setting of the tempo
Metronome function
Loading/Saving
the song data
Setting of the preroll time
Setting of MIDI sync output signal
Setting of the MTC frame rate
Setting of the MTC offset time
Setting of the MTC offset mode
Setting of the Rec protect
Setting of the digital input track
Setting of the digital output track
Setting of the bar/beat
resolution mode
Setting of the slave mode
Setting of the slave type
Setting of the MIDI device ID
Setting of the Undo function
D-160
99 (P1~P99) 9 (P1~P9)
00: 00: 00: 00: 00 00: 00: 00: 00: 00
~
23: 59: 59: 29: 59 23: 59: 59: 29: 59
44.1/48kHz 44.1/48kHz
(64 points)
(64 points)
adat, S/P DIF, SCSI adat, S/P DIF
(P1~P99)
00: 00: 00: 00: 00 00: 00: 00: 00: 00
~
23: 59: 59: 29: 59 23: 59: 59: 29: 59
(adat, S/P DIF) (adat, S/P DIF)
(adat, S/P DIF) (adat, S/P DIF)
116
D-80 V2.0
D-90 DMT-8V2.0
DMT-8VL
5 (P1~P5)
00: 00: 00: 00: 00
~ ~
06: 00: 00: 00: 00
44.1kHz
(64 points) (64 points)
(64 points) (64 points)
S/P DIF
(P1~P9) (P1~P5)
00: 00: 00: 00: 00
~ ~
06: 00: 00: 00: 00
(S/P DIF)
(S/P DIF)
DMT-8
1 (P1)
00: 00: 00: 00: 00
~
06: 00: 00: 00: 00
44.1kHz
(16 points)
(32 points)
S/P DIF
(P1)
00: 00: 00: 00: 00
~
06: 00: 00: 00: 00