Multitrack System Using A D-90/D-80 (Ver.2) /Dmt-8 (Ver.2/Vl) - Fostex D-160 Owner's Manual

6. Multitrack system using a D-90 / D-80 (Ver. 2) / DMT-8 (Ver.2/VL)
This section explains a multitrack system that uses the D-160 as master and a D-90, D-80,
D-80Ver. 2, DMT-8 Ver. 2, or DMT-8VL as slave. Using the D-160 as a master device
allows for Chase Lock operation using the Vari-pitch function or the MTC.
The example explained here uses Fostex DMT-8 Ver. 2 as a slave machine, but you can
use another model with the same settings to configure the multitrack system.
A DMT-8, which does not have a Slave Sync function, cannot be used in this system.
However, it can be used as a master device. Refer to the "Hint" described later.
Note the following when you use the D-160 along with a D-90, D-80, D-80 Ver. 2, DMT-8 Ver.
2, DMT-8VL, or DMT-8.
1. Use only Programs P1 - P5.
2. Select 44.1kHz for the sampling frequency.
3. Select S/P DIF for the digital signal. An adat digital signal can be used only on the D-90.
* Initialize the D-160 and the DMT-8 Ver. 2.
* Check the Programs on both machines (P1-P5).
* Set the sampling frequency on both machines to 44.1kHz.
Connecting the devices
* Connect DATA OUT of the D-160 to DATA IN of the DMT-8 Ver. 2, and MIDI OUT of the
D-160 to MIDI IN of the DMT-8 Ver. 2.
The best setup is to supply the MTC and S/P DIF digital signal from the master device so
slave operation will be successful.
D-160 Owner's Manual (MIDI sync function)
D-160 (Master)
DIGITAL MULTITRACK RECORDER
POWER
RECORD TRACK
1/9 2/10 3/11 4/12 5/13
PUNCH
IN / OUT
LOCKED HD ACCESS
DATA OUTPUT 1-8
DATA IN
DMT-8 ver.2(Slave)
133
<Note>
<Note>
<Note>
AUTO RTN
D-160
CLIPBOARD AUTO PUNCH
AUTO PLAY IN OUT START IN OUT END DISP SEL
AUTO RTN
COPY MOVE PASTE ERASE UNDO REDO HOLD/
AUTO
REHEARSAL
PUNCH LOCATE VARI PITCH
TAKE
RECORD STOP PLAY REWIND F FWD
6/14 7/15 8/16 SHIFT
MTC IN CLIPBOARD PLAY
LOCATE ABS 0
LOCATE ABS END
MIDI OUT
MIDI IN
EXECUTE EXIT
/YES /NO
TIME BASE SEL
STORE RECALL
PGM CHANGE