Dcd / P5V Select (Oem Option); Com3 Redirection Select (Oem Option); Bmc Enable/Disable - Supero SUPERSERVER 5015A-EHF-D525 User Manual

S S
UPER ERVER 5015A-EHF-D525 User's Manual

DCD / P5V Select (OEM option)

Jumpers J10~J13 allow selection
between the standard Data Carrier
Detect (DCD) modem signal or the
system voltage +5V on pin 1 of the
COM1~COM4 ports This is an OEM
option only.
COM3 Redirection Select (OEM
option)
JPC3 allows selection between RS232
or TTL for COM3 redirection. The de-
fault setting is RS232. This is an OEM
option only.

BMC Enable/Disable

The JPB jumper is used to enable or
disable the onboard Baseboard Man-
agement Controller (BMC) and IPMI.
This jumper is used together with the
IPMI settings in the BIOS. The default
position is pins 1 and 2 to Enable
BMC. See the table on the right for
jumper settings.
DCD / P5V Select
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
COM3 Redirection Select
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
Open
Jumper Settings
Pin Setting
Pins 1-2
Pins 2-3
5-18
Defi nition
DCD
P5V
Defi nition
RS232
(default)
TTL
Disabled
BMC
Defi nition
Enabled
Disabled