Table of Contents
Advertisement
S
S
UPER
ERVER 5015A-EHF-D525 User's Manual
2-6
Checking the Drive Bay Setup
Next, you should check to make sure the drives have been properly installed and
all essential connections have been made.
Checking the Drives
1.
Depending upon your system's confi guration, your system may have one or
two SATA drives already installed.
2.
If you need to install SATA drives, please refer to the appropriate section in
Chapter 6.
Providing Power
1.
The last thing you must do is to provide input power to the system. Plug the
power cord from the power supply unit into a high-quality power strip that of-
fers protection from electrical noise and power surges. It is recommended that
you use an uninterruptible power supply (UPS).
2.
Finish by depressing the power button on the chassis control panel.
2-8
Advertisement
Table of Contents
