Table of Contents
Advertisement
6-3
System Fans
The SC502L is a fan-less chassis, which results in an extremely quiet and energy-
effi cient operation. The only fan in the system is located on the heatsink for the
embedded processor.
6-4
Drive Bay Installation/Removal
Installling a 3.5" SATA Drive (Figure 6-3)
1.
Power down the system and unplug the AC power cord.
2.
Remove the chassis cover as described on page 2-6.
3.
Use screws to secure the drive directly into the left side of the chassis as
shown in the fi gure.
Installling 2.5" SATA Drives (Figure 6-4)
1.
Power down the system and unplug the AC power cord.
2.
Remove the chassis cover as described on page 2-6.
3.
Use screws to secure the drive into the hard drive bracket:
For two drives the bracket is p/n MCP-220-00044-0N.
For one drive the bracket is p/n MCP-220-00051-0N.
4.
Use screws to secure the bracket/drive assembly into the left side of the
chassis as shown in the fi gure.
Enterprise level hard disk drives are recommended for use in Supermicro
chassis and servers. For information on recommended HDDs, visit the
!
Supermicro Web site at http://www.supermicro.com/products/nfo/storage.
cfm
Chapter 6: Advanced Chassis Setup
6-3
Advertisement
Table of Contents
