Table of Contents
Advertisement
S
S
UPER
ERVER 5015A-PHF User's Manual
DCD / P5V Select
Jumpers J10~J13 allow selection
between the standard Data Carrier
Detect (DCD) modem signal or the
system voltage +5V on pin 1 of the
COM1~COM4 ports This is an OEM
option only.
HDA/AC97 Select
JL2 allows the user to select between
High Defi nition Audio (HDA) or legacy
AC97 audio. The default setting is
HD Audio.
COM3 Redirection Select
JPC3 allows selection between RS232
or TTL for COM3 redirection. The de-
fault setting is RS232. This is an OEM
option only.
Speaker Jumper
On the JD1 header, pins 1~3 are used
for a power LED and pins 4~7 are
used for an external speaker. If you
wish to use the onboard speaker, you
should close pins 6-7 with a jumper.
See the table on the right for speaker
pin defi nitions.
BMC Enable/Disable
The JPB jumper is used to enable or
disable the onboard Baseboard Man-
agement Controller (BMC) and IPMI.
This jumper is used together with the
IPMI settings in the BIOS. The default
position is pins 1 and 2 to Enable
BMC. See the table on the right for
jumper settings.
DCD / P5V Select
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
HDA/AC97
Jumper Settings
Pin# 1-2
Open
Closed
COM3 Redirection Select
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
Open
Speaker Connector
Pin Defi nitions
Pin Setting
Pins 6-7
Pins 4-7
Jumper Settings
Pin Setting
Pins 1-2
Pins 2-3
5-18
Defi nition
DCD
P5V
Defi nition
HD Audio
AC97
Defi nition
RS232
(default)
TTL
Disabled
Defi nition
Internal Speaker
External Speaker
BMC
Defi nition
Enabled
Disabled
Advertisement
Table of Contents
