Table of Contents
Advertisement
Compact Flash Master/Slave
Select
A Compact Flash Master (Primary)/Slave
(Secondary) Select jumper is located at
JCF1. Close this jumper to enable the
use of a compact fl ash card. For the
compact fl ash card and JCF1 to work
properly, you will fi rst need to connect
the compact fl ash card's power cable
to JWF1. See the table on the right for
jumper settings.
SMBUS to PCI Enable/
Disable
The J27 and J28 pair of jumpers allows
you to connect the System Manage-
ment Bus to the PCI expansion slots.
The default setting is closed (on) for
both jumpers to enable the connection.
Both connectors must be set the same
(J27 is for data and J28 is for the clock).
See the table on right for jumper set-
tings.
Chapter 5: Advanced Serverboard Setup
Compact Flash Card Master/
Slave Select (JCF1)
Jumper Defi nition
Open
Slave (Secondary)
Closed
Master (Primary)
SMBUS to PCI
Enable/Disable
Jumper Setting
Closed
Open
5-21
(J27/J28)
Defi nition
Enabled
Disabled
Advertisement
Table of Contents
