Driver Installation
This section provides information on how to install the
CyberParallel ExpressCard drivers.
Windows 2000
1.
At the Found New Hardware Wizard, click Next.
2.
Select Search for a suitable driver for my device
(recommended), and click Next.
3.
Check Specify a location, uncheck the other boxes,
then click Next.
4.
Insert the driver CD, type in D:\2000, then click OK.
(Change D: to match your CD-ROM drive letter)
5.
Click Next and Finish.
6.
Repeat steps 1-5 one or two times.
7.
Restart Windows to complete the driver installation.
32-bit Windows XP/Server 2003
1.
At the Found New Hardware Wizard, insert the
driver CD.
For XP w/SP1 or earlier/ Server 2003: go to step #2.
For XP w/SP2 or later/Server 2003 wSP1 or later: select
No, not this time, click Next.
2.
Select Install the software automatically
(Recommended, then click Next.
3.
Click Finish.
4.
Repeat steps 1-3.
5.
Restart Windows to complete the driver installation.
64-bit Windows XP/Server 2003
1.
At the Found New Hardware Wizard, insert the
driver CD. Select No, not this time, click Next.
4
Need help?
Do you have a question about the CyberParallel ExpressCard and is the answer not in the manual?