Windows Driver Installation; To Verify Windows Installation - SIIG Dual Profile Hi-Speed USB 4-Port PCI Manual

3. Remove the slot bracket from an available PCI slot.
4. Carefully align the card to the selected PCI slot,
push the board down firmly, but gently, until it is
well seated.
5. Replace the slot bracket holding screw to secure the
card.
6. Replace the computer cover and reconnect the power
cord.

Windows Driver Installation

Windows 2000 Service Pack 4 or later, XP Service Pack 1
or later, Server 2003, and Vista have built-in driver support
for this controller. Just install the board and Windows
will automatically detect and install the correct drivers
for it. No additional driver is necessary.

To Verify Windows Installation

1. Right click My Computer. Then click Manage.
2. Windows 2000/XP/Server 2003: Click Device
Manager
3. Windows Vista™:
Device Manager
4. Under Universal Serial Bus controllers:
- NEC PCI to USB Open Host Controller
- NEC PCI to USB Open Host Controller
- Standard Enhanced PCI to USB Host
Controller
- USB 2.0 Root Hub
- USB Root Hub (3x)
Note: Windows XP will only show two USB Root
Hub.
Click Continue, then click
3