Checking your telephone
When you first plug in your 9516CW, the telephone initializes itself and then you may see
a message asking you to make a language selection. Follow the directions on the display to
select a language.
Your telephone also runs a test to ensure that the line cord is connected properly. If the test
fails, the display prompts you to check the line cord. Make sure that all connections are
fastened securely.
Desk Mounting
Lower the stand into the slots on the base
of the telephone, as shown above.
Optional Wall Mounting
Lower the stand into the slots on the base
of the telephone, as shown above.
Adjusting the Display
Place your 9516CW on a table or hang it
on a wall, then adjust the display.
†
We recommend that you use a wall mounting plate which is available through your telephone company. If you are going to wall
mount your 9516CW, use the 20 cm (8") line cord supplied with your telephone.
Note:
The Ringer Equivalence Number (REN) is 1.4B for the 9516CW telephone. Please see the
base of your telephone or the Regulations sheet for more regulatory and safety information.
Slide the stand back until it clicks into the
locked position.
†
Slide the stand back until it clicks into the
locked position.
The Set Options Key
Move the sliding panel over to the right to
reveal the Set Options key.
5