Wan Router Configuration; Firewall Configuration; Network Using Nat; Network Configuration Guidelines For Altigen Ip Phones - Altigen ACM 6.5 Administration Manual

WAN Router Configuration

The router that connects your LAN and the WAN should support priority queuing.
•
Configure the router so that the IP/UDP packets being sent to and from an IP station
•
have higher priority than the packets generated by other stations on the same
network. Consult your router manufacturer for more information on setting up this
configuration.

Firewall Configuration

Please note the following important guidelines when working with a firewall on your
network:
If a firewall is used to protect your network access security, reconfigure the firewall
•
to open up TCP and UDP ports to the IP system's IP address. The relevant ports are
listed in Appendix C "Network Ports" on page 471. This allows IP's voice and H.323
packets to pass through the firewall freely. If the firewall supports H.323 protocol,
configure the firewall using H.323 instead of opening up the specific ports.
Ensure that the rules to permit IP's H.323 traffic are at the beginning of your access
•
filter list. This will minimize the delay of latency-sensitive voice packets. This is
especially important with long access lists and/or slow routers.

Network Using NAT

If you plan to connect to your MAXCS system via the Internet and your router or Internet
access provider is using Network Address Translation (NAT), please note that most NAT
implementations DO NOT support H.323.
You are probably using NAT if both of the following conditions apply:
•
Your MAXCS ACM server's IP address matches any of the following numbers
–
(where x is any number from 0-255):
10.x.x.x
•
172.16.x.x to 172.32.x.x
•
192.168.x.x
•
You are able to connect to the Internet directly without using a proxy server.
–
Contact your router/firewall vendor to obtain a software update for your networking
•
equipment, or obtain routable address space from your Internet provider. If you are
unsure whether or not you are using NAT, contact your router/firewall vendor or
Internet provider.
Network Configuration Guidelines for AltiGen IP
Phones
The following guidelines (specific to AltiGen IP phones) should be taken into
consideration before you configure your network for use with NAT.
DHCP is recommended to reduce the risks for duplicating IP addresses. MAXCS
•
provides seamless support for AltiGen IP phones using dynamic IP addresses. Select
Dynamic IP address for IP Extensions in the Max Admin's Extension Configuration
window.
WAN Router Configuration
MAXCS ACM 6.5 Administration Manual 331