Snmpv3 View Names; Create Snmpv3 View Names; Figure 100. Snmp Group Access Table - Allied Telesis AT-GS950/24 User Manual

Chapter 21: Simple Network Management Protocol SNMPv3

SNMPv3 View Names

Create SNMPv3
View Names
282
The SNMPv3 View names are defined in the SNMP Group Access table
and are based on the User and Group Names. You can create and delete
View Names by following the procedures in the following sections:
"Create SNMPv3 View Names" on page 282

"Modify SNMPv3 View Names" on page 283

"Delete SNMPv3 View Names" on page 283

This procedure explains how to create SNMPv3 View Names.
1. From the main menu on the left side of the page, select the SNMP
folder.
The SNMP folder expands.
2. From the SNMP folder, select Group Access Table.
The Group Access Table page is displayed. See Figure 100.

Figure 100. SNMP Group Access Table

3. Enter the Group Name.
Note
This entry must be pre-defined on the SNMP User/Group page. See
"Create SNMPv3 View Names" on page 282.
4. Enter the Read View Name.
This name is an optional field. It can be up to 31 characters in length.