User Interface Configuration; Snmp Interface; Figure 12. User Interface Page - Allied Telesis AT-GS950/24 User Manual

User Interface Configuration

SNMP Interface

This procedure explains how to enable and disable the user interfaces on
the switch. With this procedure you can enable or disable the AT-GS950/
24 SNMP Agent. For more information about SNMP, go to Chapter 20,
"Simple Network Management Protocol SNMPv1 and v2c" on page 265
and Chapter 21, "Simple Network Management Protocol SNMPv3" on
page 275.
Note
The Web Server Status is displayed as Enabled for your
information only. The Web Server cannot be disabled.
To enable or disable the AT-GS950/24 SNMP interface, perform the
following procedure:
1. From the main menu on the left side of the page, click the System
folder.
The System folder expands.
2. From the System folder, select User Interface.
The User Interface Page is displayed. See Figure 12.
3. Choose Enable or Disable from the pull down list for the SNMP Agent
parameter.
Enabled - When you enable this parameter, the SNMP agent is
active. You can manage the AT-GS950/24 switch with Network
Management Software and the switch's private MIB.
Disabled - When you enable this parameter, the SNMP agent is
inactive.

Figure 12. User Interface Page

AT-GS950/24 Web Interface User Guide
43