Static Multicast Address Configuration; Figure 82. At-Gs950/24 Static Multicast Address Table Page - Allied Telesis AT-GS950/24 User Manual

Chapter 15: MAC Address Table

Static Multicast Address Configuration

222
This procedure explains how to set the static multicast feature for each
port on the AT-GS950/24 switch.
To add a static MAC address to the switch, perform the following
procedure:
1. From the main menu on the left side of the page, select the Bridge
folder.
The Bridge folder expands.
2. From the Bridge folder, select Static Multicast.
The Static Multicast Address Table Page is displayed. See Figure 82.

Figure 82. AT-GS950/24 Static Multicast Address Table Page

Before continuing, you must create an 802.1Q VLAN ID(s) or a Port-
Based VLAN Index(s). For information about defining these
parameters, go to:
"Tagged VLAN Configuration" on page 83 regarding the 802.1Q

VLAN ID parameter.
"Port-Based VLAN Configuration" on page 91 regarding the Port-

Based VLAN Index parameter.
3. Select either the 802.1Q VLAN ID or Port-Based VLAN Index radio
button and enter the respective VLAN ID (1-4000) or VLAN Index (1 -
52).
Note
An error message is generated when you enter a VLAN ID or VLAN
Index which is not been defined or when you enter a
VLAN ID or VLAN Index without also clicking on the respective
radio button.