Albatron PX845GEV Series User Manual page 21

Connector Configuration
Front Panel Indicator: SW/LED
+ 1 2 +
- 3 4 -
- +
5 6
-
+ 7 8
9 10
SW/LED
Pin Assignment Function Pin Assignment Function
1
HD LED (+)
3
HD LED (-)
5
Reset Control (-)
7
Reset Control(+)
9
NC
HD LED (Hard Drive LED Connector)
This connector can be attached to an LED on the front panel of a computer case. The LED
will flicker during disk activity. This disk activity only applies to those IDE drives directly
attached to the system board.
RST (Reset Button)
This connector can be attached to a momentary SPST switch. This switch is normally left
open. When closed it will cause the mainboard to reset and run the POST (Power On Self
Test).
PWR-LED (Power LED Connector)
This connector can be attached to an LED on the front panel of a computer case. The LED
will illuminate while the computer is powered on.
PWR ON (Power Button)
This connector can be attached to a front panel power switch. The switch must pull the
Power Button pin to ground for at least 50 ms to signal the power supply to switch on or off
(the time required is due to internal debounce circuitry on the system board). At least two
seconds must pass before the power supply will recognize another on/off signal.
DIMM1
DIMM2
DIMM3
ATX_PWR
2
Hard Drive Power LED (+)
4
LED Power LED (-)
6
Reset Power Button(+)
8
Button Power Button(-)
10
NC
18
PX845PEV/ GEV Series
The layout is PX845PEV PRO
POWER
LED
Power-on
Button
NC NC