Table of Contents
Advertisement
Memory Installation
The PX845PEV/GEV series contains 3 sockets, which use 184 pin DDR SDRAM with a
total memory capacity of up to 2GB. You can install the unbuffered non-ECC DDR333/
DDR266/ DDR200 (PC/2700/ PC2100/ PC1600) SDRAM.
DIMM1
DIMM2
DIMM3
DIMM1
DIMM2
DIMM3
RAM Module Installation:
1.
Match the notch on the button of the RAM module with the corresponding
pattern in the DIMM slot. This ensures that the module is inserted properly.
2.
Lower the RAM module into the DIMM Slot and press firmly using both
thumbs until the module snaps into place.
3.
Repeat steps 1 & 2 for the remaining RAM modules.
Each DIMM socket is capable of using a memory
module of up to 1GB. However, if you use DIMM2
and DIMM3 at the same time, you must be install the
single-sided memory module and the total memory
used by these two sockets cannot exceed 1GB.
ATX_PWR
The layout is PX845PEV PRO
15
PX845PEV/ GEV Series
Advertisement
Table of Contents
