Table of Contents
Advertisement
CALibration
Subsystem Syntax
:COUNt?
Comments
298
Command Reference
The
subsystem has commands that calibrate the Agilent E1445A. The
CALibration
subsystem also includes commands to prevent and detect accidental or unauthorized
calibration of the Agilent E1445A. The calibration procedure using these
commands is located in the Agilent E1445A Service Manual.
CALibration
:COUNt?
:DATA
:AC[1] <
:AC2 <
[:DC] <
[:DC]
:BEGin
:POINt? <
:SECure
:CODE <
[:STATe] <
:STATe <
:AC <
:DC <
returns a number that shows how often the Agilent E1445A
CALibration:COUNt?
has been calibrated. Since executing
commands and the
CALibration:POINt?
procedure) increment the number, the
to detect any accidental or unauthorized Agilent E1445A calibration.
The Agilent E1445A was calibrated before it left the factory. Before using, read
the calibration count to determine its initial value.
The Agilent E1445A stores the calibration number in its non-volatile calibration
memory which remains intact even with power off.
The maximum value of the number is 2,147,483,647, after which it wraps around to 0.
Executable when Initiated: Yes
Coupling Group: None
Related Commands:
CALibration:SECure[:STATe]
*RST Condition: Unaffected
block
>
block
>
block
>
value
>
code
>
mode
code
[,<
>]
state
>
state
>
state
>
CALibration:DATA:AC1
query (upon completion of the calibration
CALibration:COUNt?
CALibration
[query only]
[no query]
[query only]
[no query]
,
, and
AC2
DC
command may be used
,
CALibration[:DC]:BEGin
Chapter 8
Advertisement
Table of Contents
