Rcl; Rmc - Agilent Technologies E1445A User's Manual And Scpi Programming Manual

*RCL

Parameters
Comments

*RMC

Comments
Chapter 8
*RCL < number > restores a previously stored programming state from one of the
10 possible stored state areas. The
areas should be used.
This command affects the same command settings as does
exceptions include the DAC code format (signed vs. unsigned), the
commands, including waveform segment, segment sequence, and frequency list
definitions, the
STATus
command state.
Parameter Parameter
Name
< number > numeric
Executable when Initiated: No
Coupling Group: None
Related Commands:
*RST Condition: all saved states set to the same state as the
*RMC < name > purges only the specified macro definition.
NOTE: At printing time,
and re-designation of IEEE-488.2.
Use the command to purge all macro definitions in one command.
*PMC
Executable when Initiated: Yes
Coupling Group: None
Related Commands:
*RST Condition: None
< number > indicates which of the stored state
subsystem commands, and the
Range of
Type
0 through 9
, ,
*LRN? *RST *SAV
*RMC is a command proposed and accepted for a revision
*DMC , *PMC
. Notable
*RST
[SOURce:]LIST
CALibration:SECure
Values
state
*RST
Command Reference
Default
Units
none
423