Rst; Sav - Agilent Technologies E1445A User's Manual And Scpi Programming Manual

Arbitrary function generator module scpi programming guide

Hide thumbs Also See for E1445A:

Table of Contents

*RST

Command Reference

resets the Agilent E1445A as follows:

Sets all commands to their

Aborts all pending operations including waveform generation.

does not affect:

The state of VXIbus word serial protocol

The output queue

The Service Request Enable Register

The Standard Event Status Enable Register

The enable masks for the Operation Status and Questionable Signal Registers

Calibration data

Calibration security state

Protected user data

The DAC code format (signed vs. unsigned)

Waveform segment, segment sequence, and frequency list definitions

Executable when Initiated: Yes

Coupling Group: None

*RST Condition: None

stores the current programming state into one of the 10 possible stored

state areas. The

This command stores the states of all commands affected by

include the DAC code format (signed vs. unsigned), the

including waveform segment, segment sequence, and frequency list definitions, the

subsystem commands, and the

Executable when Initiated: Yes

Coupling Group: None

indicates which of the stored state areas should be used.

CALibration:SECure

. Notable exceptions

[SOURce:]LIST

command state.