Table of Contents
Advertisement
[:CW|:FIXed]
Parameters
Comments
Example
322
Command Reference
[SOURce:]FREQuency[1][:CW|:FIXed] <
sample rate for arbitrary waveforms or waveform frequency for the built-in
waveforms (sine, square, etc.).
Parameter
Parameter
Name
frequency
<
>
numeric
MINimum selects 0 Hz.
Arbitrary Waveforms and Sine Wave Outputs: MAXimum selects the current reference
oscillator frequency divided by 4.
Square Wave Outputs: MAXimum selects the current reference oscillator frequency
divided by 16.
Ramps and Triangle Outputs: MAXimum selects the current reference oscillator
frequency divided by 4 further divided by the [SOURce:]RAMP:POINts value.
For non-sine wave outputs, multiply the MAXimum value by 2 if frequency doubling is in
effect (see the [SOURce:]FREQuency[1]:RANGe command).
The above values bound the legal range for <
Executable when Initiated: Yes
Coupling Group: Frequency
Related Commands:
TRIGger[:STARt]:SOURce
[SOURce:]FREQuency[1]:MODE
[SOURce:]ROSCillator
*RST Condition:
SOURce:FREQuency1:FIXed 10 kHz
Setting the Sample Rate or Waveform Frequency
FREQ 1E3
[SOURce:]FREQuency[1]
frequency
Range of
Type
Values
see below | MINimum | MAXimum
frequency
,
[SOURce:]FUNCtion[:SHAPe]
commands
Sets the frequency to 1000 Hz.
>
selects the non-swept
Default
Units
Hz
>.
,
,
Chapter 8
Advertisement
Table of Contents
