Setting Up Master And Slave Fs-C - Focus FS-C User Manual

FS-C Functions

Setting Up Master and Slave FS-C

Master FS-C
2
STOP 1 - 001
COUNTER
00 : 00 : 00 : 00
DISK 1
TAPE DISP LOCK
1. Connect the camcorder to the master FS-C,
using the supplied FireWire cable.
2.
Master
Power on unit.
Go to the
HDD Mode
USE EXT FS-C
3. Connect the FS-Cs through the units
using a 6-pin to 6-pin FireWire cable.
4.
Slave
Power on the unit
Go to the
HDD Mode
5.
Master
Begin recording or playback using the master FS-C.
62
4
1
000min
menu screen and enable
.
screen and enable
Use DD Drive Mode when Connecting to a PC
It is important to take the master FS-C out of USE EXT FS-C
mode before attempting to connect to a computer.
To do this, select DD DRIVE from the HDD Mode screen.
This returns use of the unit to hard disk mode.
Slave FS-C
CONNECT
COMPUTER THEN
ENABLE BYPASS
SUCCESS
EXIT
connector
DV I/O
connectors
Computer I/O
.
DD DRIVE
FS-C Portable DTE Recorder
3