Operator Panel Tasks; Taking The Printer Offline And Online - NEC SuperScript 4200N Online User's Manual

Communications Menu
This menu has settings that enable the printer to receive print
job from Parallel port or NIC, and to configure emulations
and networking protocols. See page 49 for instructions on
configuring TCP/IP parameters such as the network IP
address.
COMMUNICATIONS
PARALLEL PORT
ENABLE
PERSONALITY
PS STANDARD*
PS BINARY
PS TBCP
BIDI
NETWORK
ENABLE* / DISABLE
ETHERTALK
ENABLE* / DISABLE
NOVELL IPX
TCP/IP
ENABLE* /DISABLE
NET ADDRESS
SUBNET MASK
GATEWAY
PERSONALITY
Usage Status Menu
Use the Usage Status menu to view the total number of pages
printed. The printer resets the count whenever a Fuser Unit,
or Belt Module is installed and you reset its status in the
48 SuperScript 4200N — User's Guide
YES* / NO
ON* / OFF
POSTSCRIPT
Operator Panel.
USAGE STATUS
TOTAL PAGE COUNT
ROLLER REPLACE?
BELT REPLACE?
FUSER REPLACE?
Print Form Menu
Use the Print Form menu to select and print documents
stored in the printer.
PRINT FORM
DEMO PAGE 1
DEMO PAGE 2
PS START PAGE
PS FONT PAGE
MENU TREE PAGE
SUPPLY ORDER
O P
PERATOR ANEL
This section describes important tasks you perform using the
operator panel buttons and menu selections.
Taking the Printer Offline and Online
Press the Online button to switch between the online and
offline states.
note:
The printer must be offline before you can change
any printer settings. It must be online (indicator light on)
to print.
While the printer is offline, it continues to receive data until
its input buffer is full. If you press the Online button while
the printer is printing, it finishes the current page, and then
waits for you to bring it online again.
T
ASKS