Table of Contents
Advertisement
window, click on the Assignments button.
b. If you configured the print queue and printer
correctly they will appear in the proper boxes on the
Print Queue window. Press the Cancel button.
Installing the Printer Driver
In Windows, use the Add Printer feature to install and
configure a SuperScript 4200N printer driver in each
workstation that will access the network printer.
note:
SuperScript 4200N printer drivers are on the
SuperScript 4200N CD that comes with the printer.
Specify that the printer will be attached as a Network
Printer , and set the Port to the printer queue you just
created. (The Windows NT 4.0 driver installs automatically to
LPT1: . After installation, you can manually configure the
port to your NetWare queue.)
Using MAP and the Network Administration Page to
Configure the Printer
Now you must specify the Preferred NDS Context and
Preferred NDS Tree using the Network Administration
Page options. Continue with the instructions below, to do
this.
1.
Run MAP.
a. If you have not yet installed MAP, follow the
instructions on page 64.
b. In Windows 95/98 or Windows NT 4.0, click the
Start button. Select MAP from the program group
you specified during installation. When MAP starts,
a list of all available units on the network is
displayed by unit serial number.
2.
Select the 4200N to configure.
a. Click on a 4200N in the list under IPX printers to
display its Network Administration Page.
3.
NetWare 4.x (NDS) Configuration
a. On the Network Administration Page, click on
Setup NetWare in the Protocols column.
b. In the NetWare Configuration menu that appears,
enter a name in the Preferred NDS Context field,
and enter a name in the Preferred NDS Tree field.
70
SuperScript 4200N — User's Guide
(Leave the Preferred File Server field blank.)
c. Enter the password and click on the Accept
Settings button. (The default password is sysadm.)
4. Turn the printer off and then on again to validate
network settings changes.
5.
Confirm Successful Configuration.
a. In the Systems column, click on Reset . After the
Reset, turn the printer off, wait 10 seconds, then turn
it on.
b. Go back to the Network Administration Page, click
the Network Administration button. Then, in the
System column, click on Unit Status .
c. In the dialog box that appears, scroll down to display
the NetWare Status. The Queue Status should be
Attached .
d. If the Queue Status is not shown as Attached , please
verify that the entries for Print Server Name,
Preferred NDS Context, and Print Server Password
match those defined in NWADMIN.
Advertisement
Table of Contents
Troubleshooting
