Operator Panel Tasks; Taking The Printer Offline And Online; Setting Media Type; Stopping A Job - NEC Superscript 4650 User Manual

O P
PERATOR ANEL
This section describes important tasks you perform using the
Operator Panel buttons and menu selections.
Taking the Printer Offline and Online
Press the Online button to switch between the online and
offline states.
note:
The printer must be offline before you can change
any printer settings. It must be online (indicator light on)
to print.
While the printer is offline, it continues to receive data until
its input buffer is full. If you press the Online button while
the printer is printing, it finishes the current page, and then
waits for you to bring it online again.

Setting Media Type

When you load a new paper type into the tray, you should set
the Media type. If you do not specify the correct media type,
print quality may be poor, because the printer will move the
paper at the wrong speed. To change the Media type, on the
Operator Panel press the Media button to display
. When the correct type is displayed, the LCD
THICK STOCK
message will display
READY

Stopping a Job

If you wish to stop a print job before it is complete
1. Press the Online button to take the printer offline.
2.
PRESS SELECT--TO CANCEL JOB
display.
3. Press the Select button to cancel the job.
4. Press Online. appears on the display.
READY

Clearing the Print Buffer

The print buffer is an electronic memory in the printer where
data is kept before processing. When the Data light is
blinking, this indicates there is still data in the printer buffer.
To print out any data that is in the print buffer, press the
Online button to take the printer offline; then press the Feed
button to eject the page. (Not available in PostScript
emulation.)
T
ASKS
PAPER
.
appears on the message

Resetting the Printer

You can reset the printer to its previous settings. Follow these
steps.
1. Press Online.
2. Press Menu until
display. Press Select.
3. Press Next until
4. Press Select, and when the panel displays
press Select again.
5. Press Online. The printer performs a self test and
intialization occurs. A Startup page will print.

Resetting the NIC

You can reset the NIC to its factory default settings. Follow
these steps.
1. Press Online.
2. Press Menu until
display. Press Select.
3. Press Next until
4. Press Select, and when the panel displays
press Select again.
or
5. Press Menu, then Online.

Restoring Factory Defaults

To restore factory default settings to the printer
1. Turn off the printer.
2. While pressing the Online and Media buttons, turn on
the printer. When the display changes to
, release the button. Or follow these steps.
NVRAM
1. Press Online.
2. Press Menu until
display.
3. Press Next until
the Select button.
4. Press Next until
display, and press the Select button.
5. When the panel displays
All settings except those under the Communications
Menu will be restored to their default.
appears on the display.
OFFLINE
appears on the
MENU - CONTROL
appears on the display.
RESET PRINTER
appears on the display.
OFFLINE
appears on the
MENU - CONTROL
appears on the display.
RESET NIC
appears on the display.
OFFLINE
appears on the
MENU - CONTROL
appears on the display, and press
SETUP
appears on the
RESTORE DEFAULTS
, press Select again.
CONFIRM

Operator Panel Tasks

,
CONFIRM
,
PARAMETERS
INITIALIZE
73