Table of Contents
Advertisement
I
NSTALLING THE
1. Make sure all packing materials and tape are removed
from the printer.
2. Open the Front Cover of the printer with the Front Cover
Release Latch (A).
3.
Open the Top Cover of the printer by sliding the Top
Cover Release button forward (B)
4. Flip up the Belt Cartridge Locking Levers inside the
printer (C).
5.
Remove the Tension Release Pins from both sides of the
Belt Cartridge (D).
A
D
14
SuperScript 4200N — User's Guide
B
C
ELT
ARTRIDGE
B
E
6.
Remove the black protective sheet from around the Belt
Cartridge.
7.
Slide the Belt Cartridge into the guides, as shown (E).
(The flat side of the cartridge should face the front of the
printer.)
8.
Snap the Belt Cartridge Locking Levers into place (F).
9.
Close the Top Cover and then the Front Cover of the
printer.
note:
The Belt Cartridge is sometimes called the
Photoconductor Belt Module or OPC Unit.
C
F
Caution
slide easily into the printer. Do not
force it!
The Belt Cartridge should
Advertisement
Table of Contents
Troubleshooting
