Using The Operator Panel - NEC 4650NX - SuperScript Color Laser Printer Network Manual

Using the Operator Panel

You can use the Operator Panel to enable and set up the
TCP/IP networking parameters for the printer. This is
particularly useful for setting the network IP address so you
can use it as the printer's URL in Web-based printing (see
Chapter 9). Also, use the Operator Panel to set the IP address
on a UNIX system. Follow these steps:
1. Press the Online button of the Operator Panel.
appears on the display.
2. Press the Menu button to enter menu mode.
appears on the display.
3. Press the Next button until
on the display, and press the Select button.
4. Press the Next button until
display, and press the Select button.
5. Press the Next button until
and press the Select button.
6. Press the Next button until
display, and press the Select button.
7. Use the Operator Panel buttons to set values for each of
the 12 digits in this manner.
First press Next to set the cursor to the first digit.
For the first digit, press Select to increment to the correct
value. Then press Next to move to the next digit and
press Select to increment to its correct value. Continue
until all twelve digits are set. When the final digit is set,
press Next to confirm the Net Address you set and then
press Select.
8. Press Menu to exit menu mode and press Online to
bring the printer online.
To validate any changes to network settings, you must turn
the printer off, and then on again.
Communications Menu
This menu contains settings that enable the printer to receive
print jobs from the NIC. It can be used to configure
emulations and networking protocols. A diagram of the
network choices are shown in the box. For more information
on the Operator Panel see your SuperScript printer user's
guide.
12 SuperScript Color Laser Network Guide
OFFLINE
PRINT FORM
appears
COMMUNICATIONS
appears on the
NETWORK
appears on the display,
TCP/IP
appears on the
NET ADDRESS
Power Warning Online
Menu OnLine
Data OHT Label
Feed Item Media
Select
Previous Next
NETWORK
ENABLE* / DISABLE
ETHERTALK
ENABLE* / DISABLE
NOVELL IPX
TCP/IP
ENABLE* /DISABLE
NET ADDRESS
SUBNET MASK
GATEWAY
PERSONALITY
*Default selection for the setting.
AIS* / POSTSCRIPT / PCL