NEC SuperScript 4200N Online User's Manual page 58

2. Press the Menu button to enter menu mode.
appears on the display.
3. Press the Next button until
on the display, and press the Select button.
4. Press the Next button until
display, and press the Select button.
5. Press the Next button until
and press the Select button.
6. Press the Next button until
display, and press the Select button.
7. Use the Operator Panel buttons to set values for each of
the 12 digits in this manner.
First press Next to set the cursor to the first digit.
For the first digit, press Select to increment to the correct
value. Then press Next to move to the next digit and
press Select to increment to its correct value. Continue
until all twelve digits are set. When the final digit is set,
press Next to confirm the Net Address you set and then
press Select .
8. Press Menu to exit menu mode and press Online to
bring the printer online.
, and
SUBNET MASK GATEWAY
select , the TCP/IP protocol is enabled.
ENABLE
To validate any changes to network settings, turn off the
printer, wait 10 seconds, then turn on.
50 SuperScript 4200N — User's Guide
CONTROL
appears
COMMUNICATIONS
appears on the
NETWORK
appears on the display,
TCP/IP
appears on the
NET ADDRESS
are set in the same way. If you