Table of Contents
Advertisement
ALERT Message
OUT OF PAPER
TRAY 2 UNSUPPORTED SIZE
PAPER MISMATCH LOAD
<Paper Size> TRAY
<K, Y, M, or C> TONER EMPTY
<K, Y, M, or C> TONER NOT FOUND
PAPER JAM DRUM
PAPER JAM INNER/DRUM
PAPER JAM EXIT/DRUM
MISFEED
CHECK WASTE TONER
REPLACE FUSER OIL
REPLACE FUSER ROLLER
MISPRINT HW FAULT
BELT CARTRIDGE NOT FOUND
FUSER UNIT NOT FOUND
FUSER ROLLER NOT FOUND
FRONT COVER OPEN
BACK COVER OPEN
TOP COVER OPEN
LOW FUSER OIL
NEAR END FUSER ROLLER
REPLACE BELT
REPLACE FUSER UNIT
K-TONER LOW
<Y, M, or C> TONER LOW
120K SERVICE
CASSETTE OUT <TRAY 1 or 2>
MEDIA MISMATCH LOAD <MEDIA> TRAY
88
SuperScript 4200N — User's Guide
Explanation
One of the paper trays is empty
Paper Tray 2 contains paper size that is not supported by engine.
Paper Tray 1 or 2 does not have the correct paper size as specified for the print
job. Load the paper size shown on the display <Letter, Legal, A4, B5JIS, B5ISO,
EXEC, FOLIO, FSCAP, SPFOLI, QUARTO, COM-10, or DL>.
Specified Toner Module is empty. Replace it with a new one.
Specified Toner Module is not installed or installed incorrectly. Reinstall it.
Paper jam in Transfer Drum area.
Paper jam in back transfer area.
Paper jam in Output Tray.
Paper misfeed from Paper Tray 1 or Paper Tray 2.
Waste Toner (Toner Collector) is full or is not installed.
Fuser Oil Bottle needs replacing.
Fuser Cleaning Roller needs to be replaced.
Printing error caused by no PRREQ-N within a page. Resend the print job.
Belt Cartridge (OPC) is not installed.
Fuser Unit is not installed.
Fuser Cleaning Roller is not installed.
Front Cover is open.
Back Cover (containing Transfer Unit) is open.
Top Cover is open.
Fuser oil is low. Fuser Unit has about 30 pages of operation remaining.
Fuser Cleaning Roller has about 1000 pages of operation remaining.
Belt Cartridge worn out.
Fuser Unit reaches end-of-life.
Black Toner Module has less than 300 pages of operation remaining.
Specified Toner Module has less than 500 pages of operation remaining.
Paper Discharger, Drum Cleaner, Transfer Roller, Transfer Drum, and Paper
Pick-up Roller (in back of Paper Trays) all need to be replaced by technician.
Paper Tray 1 or 2 is not installed in Feeder.
Tray does not have the correct media as specified for the print job. Load the
media shown on the display <Paper, Label, or OHT (Transparency/OHP)>.
Advertisement
Table of Contents
Troubleshooting
