Table of Contents
Advertisement
printer controller, turn the printer off, wait 10 seconds,
then turn it on.
Factory Defaults: Click here to restore factory default
values on all NIC parameters. You should restore factory
defaults if you move the 4200N to a new network or if the
NIC was set up improperly the first time. Remember that
this option clears all settings you have defined for the
NIC. You must turn the printer off, wait 10 seconds, then
turn it on for the factory default settings to take effect.
Unit Status: Click here to view the current state for each
protocol and NIC port available on your NIC. For each
supported protocol (Novell NetWare, TCP/IP, or
AppleTalk), the top line displays the protocols supported
and if the protocol is enabled or disabled.
Network Address: Click here to view the serial number
and the Ethernet MAC (Media Access Control) address
for the 4200N.
Change Password: Changing any parameters using the
Network Administration Page requires a password. Click
here to change your password. The default password is
sysadm. Your password can contain letters, numbers, and
punctuation, and is case sensitive.
note:
If you forget your password, you can restore
factory defaults manually. See page 62.
Protocol Functions
The Protocols feature is for setting up network options and
parameters. It provides extensive access to NIC parameters,
and allows you to setup IP parameters (IP address, subnet
mask, and default gateway). You can enable/disable
AppleTalk and NetWare, but not TCP/IP. (We recommend
that you disable any protocol that you are not using.)
Other Functions
Test Printer: Click here, and then click on the Start Test
button in the dialog box that appears, to send a test
document to the printer.
Configure Status Page: Click here to configure the
Status Page options. Select the Print Status Page on
Startup check box to generate a status page (the
Network Settings page) each time you turn on the printer
or reset the NIC.
note:
We recommend that you leave this setting
checked to print at power-on.
To print out a Network Settings page immediately, click
Generate Now .
Printer Status: Click here to display status information
for the printer and NIC, as well as errors and messages.
U
MAP
SING
The Management Access Program (MAP), runs only under
Windows 95/98 and Windows NT 4.0. You use MAP to list
SuperScript 4200N network printers connected to your
network. Then you select one to go to its Network
Administration Page for network administration options.
MAP Operating Requirements
To use MAP, you must have the following installed on your
PC.
•
Netscape Navigator or Internet Explorer
•
The Microsoft TCP/IP protocol stack, if printer is going
to support TCP/IP.
For IPX Search Functions: The IPX protocol must be
installed and enabled on your PC. Both Microsoft and the
NetWare 32-bit stacks are supported.
For IP Peer-to-Peer Printing: Both your workstation
and printer must have an IP address and subnet mask
entered. If communicating across subnets, the default
gateway must also be identified.
For IPX Peer-to-Peer Printing: Your PC must have the
IPX/SPX compatible protocol installed and enabled.
Using MAP
63
Advertisement
Table of Contents
Troubleshooting
