Miele KM 404 Installation Instructions Manual page 33

Changing the jet for the inner burner
d jet disc (main jet for the inner burner)
e air sleeve
f air vent
Conversion to another type of gas
^ Remove screw c from fitting b with
an SW8 spanner and use an SW12
spanner to counterhold.
^ Then remove the screw fitting b from
a with an SW12 spanner and use
another SW12 spanner to
counterhold.
^ Take out the jet disc d held in a and
replace with the correct jet disc (see
jet table).
^ Move air sleeve e to adjust the two
air vents f to the opening illustrated
(2 mm).
^ Assemble the removed parts in the
reverse order and check for leaks by
operating the burner without the
upper part of the hob in place (use a
match to ignite the flame).
33