Microcom 428M Operator's Manual page 70

Printer Commands
The 48-466 emulation supports unique 48-466 command operations
and will process the data in the same way when technically possible.
These unique operations are briefly discussed below. Please consult
the Model 48-466 Operators Manual for additional information regarding
the command operation.
a) The printer supports the CGN lookup as defined above and in the
b) The 48-466 graphic structure is used when the emulation command
c) The ^D59 command allows format slots 121 to 128 to be overwritten
d) The ^Ax^D125 command controls the location of the euro character
The 48-466 and X24 code bases are not fully compatible, so the
emulation does have some limitations. The known limitations are briefly
mentioned below:
a) The 48-466 data stream should not use an Attribute Number of 2
b) The CS value used in conjunction with the AN set to a 2 to produce
5-20
48-466 TCI = 1, CGN #
1
2
3
4
5
6
7
8
Table 5-2
48-466 Operators manual when the emulation command is enabled.
is enabled and discussed in greater detail the 48-466 Operators
manual.
to when the emulation command is enabled.
as provided in the model 48-466 printers. The euro character which
by default is mapped to location 0xE3 (227 decimal) can be moved
to another location specified by the x if x>0. If x=0 no remapping will
take place and the euro will stay at location 0xE3. Also if the printer
must be configured to use a code page other than the default (0000)
code page.
(fixed/non-proportional) which is the seventeenth parameter. It is
not technically possible to emulate this model 48-466 feature.
a negative kerning effect should be removed and the field defaulted.
th
This is the 11 field defined in the format lines.
X24 Flash Memory Slot
1 and 2
3 and 4
5 and 6
7and 8
9 and 10
11 and 12
13 and 14
15 and 16
48-466 Compatibility Fonts
428M Operator's Manual - 880028-0112
Chapter 5