Microcom 428M Operator's Manual page 191

^A ^D COMMAND
57 Enter Label Format Mode: Instructs the printer that information for a format
is following the command.
XX 58 Process Format Saved in RAM: The ^Axx selects which stored format to
process (1-128). This command takes the selected format in RAM and makes
it into a label.
XX 59 Save Formats to RAM. (1 - 128)
60 Clears Command 61
XX 61 Mark Text Starting Position: The ^Axx designates which text field to start
entering new data.
62 Pre-Padded Text: This command is sent after the text that is to appear at the
beginning of each field.
X 63 Text Mode Control: Allows the entry of new text without the ^D2 command
and/or clears all previous text when new text is added.
0 Disable 1 and 2
1 Enable Auto-Print Mode
2 Clear all previous text upon receiving new data.
3 Enable 1 and 2
XX 64 Auto-Print String Count: The ^Axx instructs the printer how many text strings
to accept before printing.
XX 66 Clear Single FORMAT Stored in RAM: The ^Axx specifies which memory
slot to clear (1-128).
70 Clear Commands 73 through 76
71 Load MaxiCode Bar Code Data
XX 73 Load Copies Count: Instructs the printer to print a group of labels. This
command will not increment/decrement serial numbers.
X 74 Infinity Print: Continues to print copies of a format until the power is shut off.
The valid ^Ax values are "1" to enable and "0" to disable this command.
XX 75 Load Label Count: Instructs the printer to print a batch of labels using the
serial number functions if enabled.
XX 76 Load Delay Time Between Labels: The ^Axx specifies the delay time in
1/10ths of a second. Maximum value is 650.
77 Load PDF-417 Bar Code Data
428M Operator's Manual - 880028-0112 12-11