Verify The Default Video Display Driver; Verify The System Startup Version - Intergraph Intense3D Wildcat 4110 User Manual

3. From the operating system Start menu, go to Settings/Control Panel/Display/Settings/Display
Type/Change.
4. In the Change Display dialog box, click Have Disk.
5. In the Install From Disk dialog box, type the path to the directory that contains the delivery
media.
6. In the Change Display dialog box, verify that the Wildcat 4110 driver is highlighted, and then
click OK.
7. Click Yes when asked if you want to install a third-party driver.
8. After the driver files are copied, a message that the driver successfully installed displays.
Click OK.
9. Click Close to exit the Display Type dialog box, and again to exit the Display Properties
dialog box.
10. When told that the workstation must be restarted for the new settings to take effect, remove
the diskette from the workstation's floppy disk drive, if applicable. Click Yes to restart the
workstation.
11. After the system restarts and you log in, a message displays stating that a new display driver
has been installed, and that you should use the Display option in the Control Panel to select
the preferred display resolution. Click OK.
See Chapter 3, "Using the Video Card," for instructions on defining the display properties.

Verify the Default Video Display Driver

To verify the default video display driver:
1. From the operating system Start menu, go to Settings/Control Panel/Display, and click the
Settings tab.
2. Click Display Type, then verify that Intense3D Wildcat 4110 is listed under Adapter Type.
This indicates that the appropriate driver is installed.
3. Click Cancel to dismiss the Adapter Type list without making any changes.
4. Click Cancel to close the Display Properties dialog box.

Verify the System Startup Version

To verify the default system startup version:
1. From the operating system Start menu, go to Settings/Control Panel/System, and click the
Startup/Shutdown tab.
2. Verify that Windows NT Workstation Version 4.x is selected in the Startup list. If it is not,
select it from the list and click Apply.
9