14
13. After the system restarts and you log in, a message displays. The
message states that a new graphic driver has been installed, and
that you should use the Display option in the Control Panel to
select the preferred display resolution. Click OK.
14. If you want to change the display resolution or other display
settings, see the following section, "Configure the Video Display."
CAUTION
When you select Display in the Windows NT Control Panel, a
message displays. Click OK to close the message. This message
displays every time you select Display unless you clear the Show
warning at startup check box.
For more detailed installation information, refer to the
delivered on the diskette containing the video display driver.
Configure the Video Display
Open Display in the Control Panel to view the Display Properties
dialog. Use the dialog tabs to configure the operation of the computer's
video display when it is controlled by the Intense 3D Pro 2200S
Graphics Accelerator. For example, click the Settings tab to change the
screen resolution.
NOTE
If you change any video attribute settings other than gamma
correction and screen resolution, you must restart the computer to
make the changes take effect.
For more detailed configuration information, refer to the
file delivered on the diskette containing the video display driver.
Verify the Default Video Display Driver
After you configure the video display as desired, verify that the Intense
3D Pro 2200S video display driver is the default video display driver
that runs automatically when you start the computer.
To verify the default video display driver:
1.
In the Windows NT Control Panel, open System.
2.
In the System dialog, on the Startup/Shutdown tab, verify that
Windows NT Workstation Version 4.00 is selected in the Startup
list. If it is not, select it from the list and click Apply.
3.
Click OK to close the System dialog.
.
file
README
TXT
.
README
TXT
Need help?
Do you have a question about the Intense 3D Pro 2200S and is the answer not in the manual?