Configure The Video Display; Verify The Default Video Display Driver - Intergraph Intense 3D Pro 3600 Installation Manual

10
11. Click Close to exit the Display Type dialog.
12. Click Close to exit the Display Properties dialog.
13. When informed that the computer must be restarted for the new
settings to take effect, remove the diskette from the computer's
floppy disk drive and click Yes to restart the computer.
14. After the system restarts and you log in, a message displays. The
message states that a new graphic driver has been installed, and
that you should use the Display option in the Control Panel to
select the preferred display resolution. Click OK.
15. If you want to change the display resolution or other display
settings, see the following section, "Configure the Video Display."
CAUTION When you select Display in the Windows NT Control Panel, a
message displays. Click OK to close the message. This message
displays every time you select Display unless you clear the Show
warning at startup check box.
For more detailed installation information, refer to the
file delivered on the diskette containing the Intense 3D Pro 3600 video
display driver.

Configure the Video Display

Open Display in the Control Panel to view the Display Properties
dialog. Use the dialog tabs to configure the operation of the
computer's video display when it is controlled by the Intense 3D Pro
3600 card. For example, click the Settings tab to change the screen
resolution.
NOTE If you change any video attribute settings other than gamma
correction and screen resolution, you must restart the computer to
make the changes take effect.
For more detailed configuration information, refer to the
file delivered on the diskette containing the Intense 3D Pro 3600 video
display driver.

Verify the Default Video Display Driver

After you configure the video display as desired, verify that the Intense
3D Pro 3600 video display driver is the default video display driver
that runs automatically when you start the computer.
.
README TXT
.
README TXT