Appendix A: Operating State User Interface Flowchart - Teledyne 8800T Instruction Manual

Appendix A: Operating State User Interface flowchart

Viewing Teledyne
Dewpoint
DEWPOINT
Teledyne
Viewing
TEMP
Sensor
Temperature
Calibration
Menu
Teledyne
SET
Viewing
Teledyne
Serial
Number
LEGEND: 1. Arrows leading out from below a button depict the flow as a result of
2. Arrows leading out of other locations depict flow as a result of
3. A slash ' ' in the display area, is used to depict two alternately
Power ON initialization
and sign on message
a flashing
PSI legend
means pressure
correction is
8800T
being applied,
see appendix F
˚C
PSI
select
units
8800T
˚F
select
units
8800T
8800T
Press together to
RESET the Instrument.
Then quickly press and hold
MODE to go to Set-Up State.
pressing the button.
completing a function or a time-out.
shown (flashing back and forth) messages.
30 seconds anywhere
other than calibration
without a key press
1sec.
Confirm
SpanCheck™
Teledyne
1 minute
Sensor
Reading
Too Low
OK
Teledyne 8800T
SET
numbers calculating
calibration
page 31
Appendices
Teledyne 8800T
Teledyne 8800T
SET
8800T
SET
Teledyne 8800T
SET
Teledyne 8800T
SET