Ricoh RW-480 PLOTCLIENT HDI/ADI Software Manual page 98

• Mirror
In this area you can set whether the drawing is to be mirrored or
not during plotting. You can choose from four options
OFF: The drawing is not mirrored during plotting.
X: The drawing is mirrored horizontally.
Y: The drawing is mirrored vertically.
XY: The drawing is mirrored about both axes simultaneously;
equates to a 180° rotation.
You usually use these settings if the drawing has been scanned
and saved with a mirror inversion. This is especially important if
a translucence has been scanned with mirror inversion to in-
crease the contrast
• Output
You have two possibilities for the output of your printouts on
plotter RW-480: front and rear. The standard setting is output at
the front.
• Media Source
You can select one of the plotter rolls offered. In addition, you
can also choose the "automatic" or "manual" options. The
"automatic" option means that the plotter itself selects a suitable
roll, which corresponds to the given format. The "manual" op-
tion means that you feed the print medium in the input tray
yourself.
• Rotate
Here you can set whether the drawing is to be rotated or not
during plotting. Rotations of 0°, 90°, 180° and 270° are possi-
ble. When set to "Auto", RW-480 PLOTCLIENT HDI/ADI rotates
automatically if this results in less waste paper.
• Cut Mode
The selections available are "Synchro" and "Format". If you
choose "Synchro", the plotter cuts the drawing immediately after
the last data has been printed. This results in optimum paper or
medium use, because it produces the smallest amount of waste
On the other hand, if you want the printout to always be cut to a
standard format, irrespective of how much space remains un-
used, activate "Format". The plotter then always cuts to the next
PRESETS FOR PRINT JOBS
RW-480 CLIENTS 98