Ricoh RW-480 PLOTCLIENT HDI/ADI Software Manual page 148

use the ftp command as follows to send print jobs to the RW-
480 PLOTBASE via RW-480 WINPRINT:
1. Open the prompt on the UNIX computer.
2. Change to the folder containing the files to be printed.
3. Enter the command "ftp [computer name
The system changes to the ftp subsystem and sets up a net-
work link to the required computer.
4. You are now asked for the name of the user. Enter "anony-
mous" and confirm with the return key.
5. Confirm the password query by simply not entering a
password.
6. Now enter the "binary" command for transmission in binary
mode and confirm with the return key.
7. Enter the following command if you want to print a file. If
you want to print several files, proceed with Item 8. For one
file, the command is:
8. If you want to print several files at once, enter the following
command:
9. If a file comes from another folder than the current folder,
enter the path as well as the file name, as shown in the fol-
lowing:
mput <filename> <path>\<filename>
If you send a file without print parameters to RW-480
PLOTBASE, the RW-480 PLOTBASE basic settings are used. If
you want to send your own print parameters with the plot, you
have to first send the CFG file, which must have the same name
as the graphic file, and then send the graphic file itself!
put <filename>
= put graphics.tif
mput <filename> <filename> ...
= mput graphics.tif city.plt
= mput graphics.tif tmp\city.plt
RW-480 PLOTCLIENT FTP
computer-IP]".
or
RW-480 CLIENTS 148