Table of Contents
Advertisement
Maintenance and service
12.5 Installing Software
Functions for RAID system management
The preinstalled software of the RAID system offers enhanced functions for using and
managing the RAID system.
SATA-RAID software is started via "Start > Programs > Promise Array Management > Local
PAM".
Access to the RAID is protected by user and password. Factory setting:
• User: Administrator
• Password: empty
12-42
Notice
The security functions of the RAID system are effective without launching the software.
The RAID status is always indicated in the Windows status bar. In the event of an error, a
hard disk can be duplicated by means of the RAID Controller BIOS or on the operating
system level. It may take up to several hours to synchronize a new disk in the
background, depending on the size of the hard disk and on the system load.
The redundant system state RAID Level 1 is reached again only after synchronization is
completed.
Operating instructions, Release 07/2006, A5E00877780-01
SIMATIC Panel PC 877
Advertisement
Table of Contents
