Table of Contents
Advertisement
Installation
5.1
Securing the device with clamps
5.1
You require 6 clamps in order to mount the device with a 12"/15" display. A device with a 19"
display must be mounted with 8 clamps. The required number of clamps is included in your
Panel PC delivery package.
Required tool for fasting the clamps: 2.5 mm hexagonal spanner
Figure 5-1
Rack installation
Steps for fastening the device with clamps
1
2
3
Swivel arm installation
Steps for fastening the device with clamps
1
2
3
Switchgear cabinet installation
Steps for fastening the device with clamps
1
2
3
SIMATIC Panel PC 877
Operating instructions, Release 07/2006, A5E00877780-01
Clamp assembly
Disconnect the device from the power supply.
Working from the front, insert the device into the 19" rack.
Fasten the control unit in the rack from the rear using the clamps. Tighten the setscrews to a
torque of 0.4-0.5 Nm.
Disconnect the device from the power supply.
Working from the front, place the device onto the swivel arm.
Fasten the control unit on the swivel arm from the rear using the clamps. Tighten the setscrews
to a torque of 0.4-0.5 Nm.
Disconnect the device from the power supply.
Working from the front, insert the device into the mounting cut-out.
Secure the control unit in the mounting cut-out from behind with the clamps, as shown in the
mounting cut-out in the dimensions. Tighten the setscrews to a torque of 0.4-0.5 Nm.
5
5-1
Advertisement
Table of Contents
