Table of Contents
Advertisement
Figure 12-7
4. Remove the connector of the ribbon cable from the socket (2).
5. Loosen the 3 screws (3) with a TX6 key.
6. Remove the drive (4) from the bracket.
7. Loosen the 2 screws (5) on the board (6).
8. Remove the board (6).
Reverse the procedure to install the drive.
SIMATIC Panel PC 877
Operating instructions, Release 07/2006, A5E00877780-01
Drive removed, housing flipped up
Notice
Loose spacer bolts are located between the housing and the board. When loosening the
board, hold the spacer bolts in place.
12.4 Installing and removing hardware components
Maintenance and service
12-23
Advertisement
Table of Contents
