Installing The Video Interface (Vif4); Ntsc, Pal, Secam; Precautions; Installation - Korg pa2X pro User Manual

Professional arranger
Hide thumbs Also See for pa2X pro:
Table of Contents

Advertisement

Installing the Video Interface (VIF4)

You can install a Korg VIF4 Video Interface into your Pa2X. This
interface will let you connect a video monitor, TV set, video
recorder or video projector, to read lyrics on an external device.
The card can be installed by the user. Korg is not responsible for
any damage or injury caused by incorrect installation of this
card by unauthorized personnel.

NTSC, PAL, SECAM

The VIF4 is compatible with the NTSC, PAL and SECAM TV
standard. When connecting a SECAM-compliant TV set, select
the PAL standard. However, in this latter case, the image will be
shown in black and white.

Precautions

• Installation of the card is done at the user's own risk. Korg will
assume no responsibility for any damage or injury resulting
from its improper installation or use.
• Be sure to disconnect the instrument from the AC plug, before
opening it.
• To prevent your body's static electricity from damaging the
board's components, touch an unpainted metallic component
before proceeding with the installation.

Installation

For installation, you will need a cross-point screwdriver (not sup-
plied).
1.
Extract the video card (a) from its package, being careful
not to touch any component on its surface with your fin-
gers. Remove the four screws (b) and keep them apart.
Unfasten the board (a) from the metal support (c).
Installing the Video Interface (VIF4)
2.
From the bottom of the instrument, remove the four fixing
screws (d), and keep them apart. Open the cover (e) to gain
access to the inside of the video board slot. Remove the
protective stopper (f) by pushing it from inside the slot.
3.
After having opened the cover (e), unfasten the power cable
(i) by removing the screw (g) and the clip (h). Be very care-
ful not to let the power cable (i) fall inside the insturment.
4.
Attach the cover (e) to the circuit board (a) by using the
four previously removed screws (b). Connect the power
cable (i) to the circuit board (a), as shown in the illustra-
tion.
329
NTSC, PAL, SECAM

Advertisement

Table of Contents
loading

Table of Contents