Table of Contents
Advertisement
LEFT, RIGHT These are the main stereo outputs. Use them to
send the final stereo mix to an external device.
Connect either of them to output the signal in
mono. Set the output level with the MASTER
VOLUME slider.
1, 2
These are the sub outputs. Use them to create a
stereo sub-mix of just some tracks, or to output
just a single instrument to be mixed alone, or to
be processed or amplified externally.
Note: The MASTER VOLUME slider has no effect
on these outputs. Signal is sent dry, with no effects
applied.
DIGITAL OUTPUT
Use this 48 kHz S/PDIF output to connect the
Pa2X to the S/PDIF input connector of another
digital device, like a digital mixer, audio card, or
stand-alone CD recorder. The same signal output
from the Left and Right connectors is sent by this
connector. See "S/PDIF Enable" on page 234 for
more information.
7
MIDI INTERFACE
The MIDI interface allows your Pa2X to be connected to external
controllers (master keyboard, MIDI guitar, wind controller,
MIDI accordion...), to a series of expanders, or to a computer
running a sequencer. For more information on how to use the
MIDI interface, see the "MIDI" chapter.
IN
This connector receives MIDI data from a com-
puter or a controller. Connect it to an external
controller's or computer's MIDI OUT.
OUT
This connector sends MIDI data generated by
Pa2X's keyboard, controllers, and/or the internal
player. Connect it to an expander's or computer's
MIDI IN.
THRU
This connector sends an exact copy of the data
received on the IN connector. Use it to cascade
the Pa2X with other MIDI instruments.
8
PEDALS
EC5
This connects to a Korg EC5 multiswitch pedal-
board, to control many functions in realtime. To
program the EC5, see "EC5-A...E" on page 227.
ASSIGNABLE Use this port to connect a continuous- or foot-
switch-type pedal, like the Korg EXP-2, XVP10,
or PS-1. To program and calibrate it, see "Pedal/
Footswitch" on page 226.
DAMPER
Use this to connect a Damper pedal, like the Korg
PS-1 or DS1H. To change its polarity and cali-
brate it, see "Damper" on page 227.
Note: Half-pedalling on Piano Sounds is available
when connecting a DS1H damper pedal.
9
USB
HOST(R)
This is a USB Type A (Master/Host) connector,
USB 2.0 compliant (High Speed). It duplicates
the USB connector located in the front panel. Use
it to connect to the Pa2X an USB Flash Memory
stick, an external CD-ROM drive, an USB hard
disk. To access the connected device, go to the
Media edit mode (see "Media edit mode" on
page 249).
DEVICE
This is a USB Type B (Slave/Device) connector,
USB 1.1 compliant (Full Speed). Use it to connect
the Pa2X to a personal computer, and transfer
data to/from its internal devices (SSD, Hard
Disk). See "HD and SSD-U Connection" on
page 265 for more information.
MIDI Over USB is supported, so you can use this
connector instead of the MIDI ports (see "What
is MIDI Over USB?" on page 269). The drivers
for PC and Mac needed for full use of this func-
tion are supplied in the Accessory CD that comes
with the instrument, or can be downloaded from
our web site (www.korgpa.com).
Rear panel
15
Advertisement
Table of Contents
