Table of Contents
Advertisement
scroll to the previous or next Song in the Jukebox
list (see "Jukebox Editor" on page 176).
(HOME)
Sends the Song Position back to measure 1 (i.e.,
the beginning of the Song).
In Sequencer mode, if you set a Locate Measure
other than 1, the Song Position goes back to that
measure (see "Locate measure" on page 194).
(PLAY/STOP)
Starts or stops the Song from the current Song
Position.
In Song Play mode, pressed while keep-
ing SHIFT pressed, starts both players at the same
time.
W
X-FADER
In Song Play mode, this slider balances the volume of the two
on-board players. When fully on the left, only Player 1 can be
heard. When fully on the right, only Player 2 can be heard. When
in the middle, both players play at full volume.
This slider also selects the Harmony Track from one of the two
players. It also selects the Lyrics, Score and Markers from one of
the players, assuming the "Lyrics/Score X-Fader Link" parameter
is turned on (see page 179).
Note: This slider does not work in Style Play or Sequencer mode.
X
PLAYER 2 TRANSPORT CONTROLS
Transport controls for Player 2. See instructions for Player 1
above.
Y
TEMPO/VALUE section
The DIAL and the DOWN/- and UP/+ buttons can be used to
control the Tempo, assign a different value to the selected
parameter in the display, or scroll a list of files in the Song Select
and Media pages.
DIAL
Turn the dial clockwise to increase the value or
tempo. Turn it counter-clockwise to decrease the
value or tempo.
When used while pressing the SHIFT but-
ton, this control always acts as a Tempo control.
When used while pressing the MENU
button, this control always acts as a Display Con-
trast control.
DOWN/- and UP/+
DOWN/- decreases the value or tempo; UP/+
increases the value or tempo.
Press both buttons together to reset the Tempo to
the value memorized in the selected Style.
Z
EXIT
Use this button to perform various actions, leaving from the cur-
rent status:
•
exit the edit menu page, without selecting any item
•
make the page menu disappear, without selecting any
item
•
return to the main page of the current operating mode
•
exit the Global or Media edit environment, and return
to the current page of the current operating mode
•
exit from the SongBook mode
•
exit from the Lyrics page
•
exit from a Style, Performance or Sound Select window
[
MENU
This button opens the edit menu page for the current operating
mode or edit mode. After opening an edit menu, you can jump
to one of the edit sections by touching the corresponding button
in the display.
Otherwise, press EXIT to return to the main page of the current
operating mode, or the current page of the underlying operating
mode.
See the relevant chapter devoted to each operating mode or edit
environment, to see their "maps" in detail.
\
DISPLAY HOLD
This button turns the Display Hold function on or off.
On
When you open a temporary windows (like the
Sound Select window), it remains in the display
until you press EXIT or an operating mode but-
ton.
Off
Any temporary window closes after a certain
time.
]
LYRICS
This button recalls the Lyrics page for the active Player. You can
use the X-Fader to select either Player 1 or Player 2 (see "Lyrics/
Score X-Fader Link" on page 179).
Sty
SB
`
ACCOMPANIMENT – CHORD SCANNING section
In Style Play, Song Play and Sequencer-Backing Sequence mode,
use these buttons to define the way chords are recognized.
LOWER
Chords are detected below the split point. The
number of notes you should play to form a chord
is defined by the Chord Scanning Mode parame-
ter (see "Chord Recognition Mode" on page 109).
UPPER
Chords are detected above the split point. You
must always play three or more notes to let the
arranger recognize a chord.
FULL (both LEDs On)
Chords are detected on the full keyboard range.
You must always play three or more notes to let
the arranger recognize a chord. (You can use this
mode even when the Split keyboard mode is
selected).
OFF
No chords detected. After pressing START/STOP,
only the Drum and Percussion accompaniment
tracks can play.
a
SPLIT
In Style Play, Song Play and Sequencer-Backing Sequence mode,
use this button to define how the four Keyboard tracks are posi-
tioned on the keyboard, and how chords are recognized by the
arranger.
Front panel
11
SB
SB
Advertisement
Table of Contents
