Grease-Up Procedure - JUKI APW-896/IP-420 Instruction Manual

(1) Grease-up procedure

2
1
5
3
4
7
8
A
9
!0
6
− 102 −
1 Loosen two screws 1 (SM6040602TP) and
move wiper cylinder 2 to the right side.
2 Loosen two screws 3 (SM4050655SP) and
move face plate cover 4 to the left side. At
this time, be careful of moving the cover along
escape A of the cover so that it does not come
in contact with plate spring 5 .
3 Replenishment of grease to the center knife
section
• Apply grease to both planes of guides 8 , knife
bar metal, upper 9 , and knife bar metal, lower 6 .
• Knife bar !0 moves up and down by moving
cylinder joint 7 up and down in the state that air
is not supplied. Apply grease to the metal so as
to infiltrate the inside.