Installation Of The Sewing Machine - JUKI LH-3500A series Instruction Manual

3-2. Installation of the sewing machine

(1) Installing the under cover
3
1
) The under cover should rest on the four corners
of the machne table groove.
7
8
3) Mount rubber hnge seats 7 on the table and fix the
table wth nals.
Insert hnge 6 nto the machne man body. Engage the hng-
es wth rubber hnge seats 7 mounted on the table. Then,
put the machne head down on the machne head cushons
8 whch are located at the four corners of the table.
!0
5) �etach nlet port !0 for circulation which is fixed on the feed box cover. Insert the inlet port into filter !1
untl t wll go no further wthout fal and place them n openng C .
Place urethan filter !2 on D , and place filter !3 of thn plate type (small mesh plate) on t.
Circulation trouble may occur unless inlet port !0 for circulation is securely inserted into filer !1
until it goes no further.
22.5mm
3
1
2
2) Fx two rubber seats 1 on sde A (operator's
sde) usng nals 2 as llustrated above. Fx two
cushon seats 3 on sde B (hnged sde) usng a
rubber-based adhesve. Then place under cover
4 on the fixed seats.
6
!3
– 5 –
4
1
A B
9
6
7
4) Attach head support rod 9 to the table.
!0
D
!2
18.5mm
3
!1
C